*DISCONTINUED* Honda Aquatrax Replacement Hand Grips-ROGUE LOCK ON GRIPS 120MM

*PART IS NO LONGER AVAILABLE* ROGUE LOCK ON GRIPS for 120MM Handle Bars

Fits ALL Honda Aquatrax with minor modifications.

Honda uses a safety bar with a flanged end. The flange doesn't allow you to remove the grips or install new grips. Use a razor knife to cut the old grip off the handlebar, then use a hacksaw or similar saw to cut just the flange off the handle bar, roughly 1/4". By removing this flange, you will be able to install aftermarket grips without replacing the entire handle bar assembly.

Patented Lock-On Grip system uses four aluminum Lock Jaw Clamps (two on either grip) to lock your grips onto the bars.  They can be removed or installed in just a few seconds without using any glues or ties and without destroying your grips each time. Simply snap the aluminum Lock Law Clamp onto the bars on either end of the grip. Slide the grip to the desired position on the handlebars and lock them into place by tightening the allen bolts in each clamps.

Write Your Own Review
You're reviewing:*DISCONTINUED* Honda Aquatrax Replacement Hand Grips-ROGUE LOCK ON GRIPS 120MM