CUSTOM HONDA F12 F12X SEAT COVERS

HONDA AQUATRAX CUSTOM SEAT COVERS BY BLACKTIP.

Our custom made Honda F12 and f12x Seat Covers are a greta way to bring new life to an aging dull Jet Ski. These Aquatrax seat covers are made to fit all years of the F12(Non-Turbo 3 passenger) and F12X(Turbo 3 passenger) Honda Watercraft.

We have 3 versions ready to ship:

  • Red/Black Vinyl
  • Blue/Black Vinyl
  • Silver Carbon Fiber/Black Carbon Fiber

If you would like a different color combination please give us a call at 813-413-7544 or use the Contact Us form so we can help you get exactly what you want.

Please note all seat covers are custom made to suit your specific color and material.

**There are no refunds or exchanges so please make sure to order correctly.

Additional colors available:

Vinyl color choices: Black, Deep Blue, Royal Blue, Teal, Burgundy, Gray, Dark Gray, Dark Green, Lime Green, Purple, Red, White, Yellow and Orange.

Carbon-Fiber color choices: Black, Silver, Purple, White, Copper, Dark Gray, Yellow, Blue and Red.

Non Slip Material available in Black.

Scroll Down for Installation instructions and cleaning instructions

Blacktip offers a 1 year Manufacturers Warranty against defects in the material and workmanship! The warranty does not cover fading, tearing or stains due to user negligence.

Installation:

Installation of your new seat cover is easy and can be done by most do it yourselfers. Listed below are the tools and supplies you will need:

Staple Gun (preferably electric or air powered)
Stainless Steel staples to fit your gun
Needle nose pliers
Flat blade screwdriver or other type of tool to pry out staples
Scissors
Utility knife
Some seats have straps, handles, or brackets they may require additional tools for removal.

Most BlackTip Jetsports seat covers are designed to install over your factory cover. The old cover may need to be removed or sections of it removed if it is torn or damaged. If the original is badly damaged or the seat foam is wet you should remove it completely and let the foam dry before installing the new cover.

If the foam is damaged you will need to repair it before installing the new cover or the damage will show through. Small cracks can usually be repaired with duct tape to hide the damage. Larger repairs can be made by replacing the damaged foam and then sanding the new foam to match the shape of the old foam. If your seat has extensive damage we recommend taking it and your new cover to a local upholstery shop.

Installation of the cover is easiest if the vinyl is warm, a nice sunny day, a warm shop, or a hair dryer can accomplish this. Make sure you do not have any sharp corner or protrusions before installing.

Align the cover onto the seat so that it is centered over the main section of the seat. Put a staple at each corner or curve including the front of the seat (these staples may need to be removed later as you stretch the material into place). Once you have the material aligned you can continue stretching and fitting the cover around the seat. As you staple and stretch it may be necessary to trim away excess material. You will want to use many staples around the perimeter of the seat use the original as your guide. After the cover is completely stapled in place you should trim away any excess material.

On some models with a strap you can reinstall the strap at this time if you prefer.

Cleaning and Care:

Cleaning and Maintenance of the seat cover should be done periodically to help extend the life of the cover. To clean the cover, we suggest a mild liquid soap similar to soap used to wash the PWC. For bird droppings or other hard to clean spots, it may be necessary to use a scrub brush. You can rinse the cover with a standard garden hose. We do not suggest using a pressure washer since the pressure could be high enough to damage the material.

 

Write Your Own Review
You're reviewing:CUSTOM HONDA F12 F12X SEAT COVERS